INDUSTRIES - FACTORIES WHERE THERE ARE APPLICATIONS WITH WATER

MANUFACTURERS AS CLEANING, PROFESSIONAL WASHING MACHINES AND CARWASHING, MILLS, TANNERIES, WINERY, MILK PLANTS, ICE FACTORIES, BAKERIES, CONFECTIONERIES, CONCRETE PRODUCTION

In boilers / heating systems / Alternatively heat / steam generators / boilers / Compressors / injection systems / cooling towers / plastic production systems (extrounter) / Industrial washing / sterilization systems / Water Cooled Engines / Ice. Generally where there is any water application and thus scales'problem.

IN BOILERS / HEAT EXCHANGERS

Not destroyed by the scales and corrosion and thus multiplied their lifetime. Prevents costly damage (punctures, burnt resistors). It allows the maximum performance. Becomes energy economy because studies showed that limscale 1 mm thick increases the energy transfer time between two surfaces by 6-10% and the required energy by 7-15%. Thus the use of AQUA SOFT II brings gain in time and energy (oil or electricity). Stops electrolysis. It also significantly reduced and abolished the use of specific chemicals which besides cost are harmful to humans and the environment.

IN STEAM BOILERS / STEAM GENERATORS

Exactly the same as those applied in the boilers. Also, especially for steam boilers except that no recapture limescale and they are protected by electrolysis and corrosion will be improved to 10% efficiency of the steam and reduce 10% the time the system starts to produce steam. This is because water in the normal state begins to boil (i.e., to release gases - information water to begin to disintegrate the need first to free the gas) at around 85 to 90 degrees, while in the treated water due to the reduction of the surface tension of voltage begins to boil at a lower temperature than the untreated (reported case starts to boil by 55 degrees). This results in more efficient operation of the boiler and the reduction of energy use required to produce steam.

IN AIR-CONDITION (HEADUNITS - COOLING TOWERS / ZILLER)

Full salts detachment. The compressor is cooled and fixed working at full performance. No problems are created in the cooling tower and piping.

IN WATER COOLED SYSTEMS - COOLING TOWERS

After using the electronic water processor AQUA SOFT II will have more detail the following results:

Fully remove the limescale from the interior of the closed circuit piping, and the cells, thus avoiding:

a) The deterioration of cells and their replacement

b) The erosion of the walls of the bowl and oxidation.

c) The cost of chemical cleaning (chemical-downtimes).

d) The temporal decay of the towers because of chemical cleaning and particularly the alternator.

e) The increased power consumption which comes from the performance reduction of cooling capacity of the circuit because of the deposits of calcium carbonate.

THE APPLICATION OF AQUA SOFT II ON COOLING TOWERS YOU HAVE:

• Increase overall system performance due to the reduction of latent heat.
• This is due to the reduction of surface tension of water and the change (reduction) in viscosity.
• In view of the foregoing have resulted in the reduction of energy consumption.